HMORefurbishment

Derbyshire, England

Damp, mould and HHSRS repairs in High Peak

Damp, mould and HHSRS repairs for shared houses in High Peak: survey, itemised quote, works and a licence-ready handover, covering S33, SK17, SK22 and SK23.

Empty bedroom being redecorated between tenancies, with dust sheets, ladder and new carpet

Damp and mould in an HMO is usually caused by condensation, leaks or rising or penetrating damp, and often by a mix. High Peak is 16 miles west of Sheffield. We price damp, mould and HHSRS repairs there against England’s HMO rules and the council’s written HMO standards, so work is planned to the standard an inspection looks for.

Area
Derbyshire, England
Postcodes
S33, SK17, SK22 and SK23
Location
16 miles west of Sheffield
Pricing region
East Midlands

What do damp, mould and HHSRS repairs in High Peak involve?

  • Damp-proofing where it is the cause
  • Leak, gutter and roof repairs
  • Re-plastering and making good
  • Extraction and continuous ventilation
  • Cause-finding survey with moisture readings

Which rules apply in High Peak?

The rules below are the England-wide position for this kind of work. Councils add their own standards and schemes on top, so we always check the address in High Peak before we price.

  • Councils assess hazards, including damp, mould and fire, under the HHSRS; revised regulations and guidance applied from 23 June 2026.
  • Rented homes must currently meet at least EPC E, with a £3,500 spending cap. The government plans EPC C by October 2030, subject to legislation.
  • Councils can fine up to £7,000 where a Category 1 hazard is not removed when it reasonably could have been.

How much do damp, mould and HHSRS repairs cost in High Peak?

ItemUK typicalLocal guidePer
Damp repair, from a single wall to a whole house£600 – £4,000£580 – £3,900job
Mould treatment and making good£250 – £500£240 – £480room

Prices in High Peak are shown with our regional adjustment for East Midlands (below the UK average). Your quote is itemised and fixed in writing once the scope and specification are agreed.

How long does it take?

Most jobs of this kind take 2–10 working days. If a council deadline applies in High Peak, tell us at the first call so the programme is built around it.

When do High Peak landlords need it?

Typical reasons for this work in High Peak:

  • An HHSRS finding or council letter
  • Recurring mould in bathrooms and bedrooms

Questions about damp, mould and HHSRS repairs in High Peak

Is damp always rising damp?

No. In shared houses condensation is the most common cause, because of cooking, showers and drying clothes. We find the cause before recommending any treatment.

How far do you travel from High Peak?

We cover the whole of Derbyshire and work UK-wide. For High Peak the nearest towns on our list are Buxton (8 miles), Hyde (11 miles), Hazel Grove (11 miles).

Where do I check the HMO rules for an address in High Peak?

With the local council for the address. Councils in England can add additional licensing and Article 4 directions on top of the national rules. Check the council’s website for the exact address before you buy or start work.

How much do damp, mould and HHSRS repairs cost in High Peak?

Our guide ranges for East Midlands are in the table on this page, and the guide-price tool gives a figure for your house. A fixed written quote follows a free site visit.

Damp, mould and HHSRS repairs near High Peak

Other HMO services in High Peak

Planning HMO works?

Free site visit, then a fixed written quote itemised against your council’s standards.

CallGet a quote