HMORefurbishment

Greater London, England

Damp, mould and HHSRS repairs in Richmond

Damp, mould and HHSRS repairs in Richmond and the TW9 and TW10 postcode areas, for landlords and investors with shared houses across Greater London. Free site visit, then a fixed written quote.

Empty bedroom being redecorated between tenancies, with dust sheets, ladder and new carpet

Damp and mould in an HMO is usually caused by condensation, leaks or rising or penetrating damp, and often by a mix. Landlords in Richmond (TW9 and TW10) usually come to us with a council letter, a fire risk assessment or a house they have just bought. We price from whichever you have.

Area
Greater London, England
Postcodes
TW9 and TW10
Location
8 miles south-west of London
Pricing region
London

What do damp, mould and HHSRS repairs in Richmond involve?

  • Mould treatment and stain-block
  • Extraction and continuous ventilation
  • Re-plastering and making good
  • Photo report of before and after
  • Cause-finding survey with moisture readings

Which rules apply in Richmond?

The rules below are the England-wide position for this kind of work. Councils add their own standards and schemes on top, so we always check the address in Richmond before we price.

  • Councils assess hazards, including damp, mould and fire, under the HHSRS; revised regulations and guidance applied from 23 June 2026.
  • Rented homes must currently meet at least EPC E, with a £3,500 spending cap. The government plans EPC C by October 2030, subject to legislation.
  • Councils can fine up to £7,000 where a Category 1 hazard is not removed when it reasonably could have been.

How much do damp, mould and HHSRS repairs cost in Richmond?

ItemUK typicalLocal guidePer
Damp repair, from a single wall to a whole house£600 – £4,000£770 – £5,100job
Mould treatment and making good£250 – £500£320 – £640room

Use these as a starting point for budgeting. Access, condition and the council’s requirements in Richmond can move the figure either way, which is why we quote after seeing the house.

How long does it take?

Typical time on site: 2–10 working days. We agree the programme with you before starting and send photo updates as the work progresses.

When do Richmond landlords need it?

Landlords in Richmond most often ask us for this when:

  • An HHSRS finding or council letter
  • Recurring mould in bathrooms and bedrooms

Questions about damp, mould and HHSRS repairs in Richmond

Is damp always rising damp?

No. In shared houses condensation is the most common cause, because of cooking, showers and drying clothes. We find the cause before recommending any treatment.

How far do you travel from Richmond?

We cover the whole of Greater London and work UK-wide. For Richmond the nearest towns on our list are Isleworth (2 miles), Hounslow (2 miles), Barnes (3 miles).

Where do I check the HMO rules for an address in Richmond?

With the local council for the address. Councils in England can add additional licensing and Article 4 directions on top of the national rules. Check the council’s website for the exact address before you buy or start work.

How much do damp, mould and HHSRS repairs cost in Richmond?

Our guide ranges for London are in the table on this page, and the guide-price tool gives a figure for your house. A fixed written quote follows a free site visit.

Damp, mould and HHSRS repairs near Richmond

Other HMO services in Richmond

Planning HMO works?

Free site visit, then a fixed written quote itemised against your council’s standards.

CallGet a quote