HMORefurbishment

Kent, England

Damp, mould and HHSRS repairs in Royal Tunbridge Wells

Planning damp, mould and HHSRS repairs in Royal Tunbridge Wells? We survey, price and build HMO works across Royal Tunbridge Wells (TN1, TN3 and TN4) and the rest of Kent.

Empty bedroom being redecorated between tenancies, with dust sheets, ladder and new carpet

Damp and mould in an HMO is usually caused by condensation, leaks or rising or penetrating damp, and often by a mix. In Royal Tunbridge Wells, a town of around 70,000 people in Kent, the work is planned around the HMO rules for England and the council’s written HMO standards.

Area
Kent, England
Postcodes
TN1, TN3 and TN4
Location
27 miles north-east of Brighton
Pricing region
South East

What do damp, mould and HHSRS repairs in Royal Tunbridge Wells involve?

  • Extraction and continuous ventilation
  • Leak, gutter and roof repairs
  • Mould treatment and stain-block
  • Insulation to cold spots
  • Cause-finding survey with moisture readings

Which rules apply in Royal Tunbridge Wells?

Here is what usually applies to a Royal Tunbridge Wells job of this kind. It is general information rather than legal advice, and the council’s written HMO standards have the final detail.

  • Councils assess hazards, including damp, mould and fire, under the HHSRS; revised regulations and guidance applied from 23 June 2026.
  • Rented homes must currently meet at least EPC E, with a £3,500 spending cap. The government plans EPC C by October 2030, subject to legislation.
  • Councils can fine up to £7,000 where a Category 1 hazard is not removed when it reasonably could have been.

How much do damp, mould and HHSRS repairs cost in Royal Tunbridge Wells?

ItemUK typicalLocal guidePer
Damp repair, from a single wall to a whole house£600 – £4,000£670 – £4,500job
Mould treatment and making good£250 – £500£280 – £560room

Prices in Royal Tunbridge Wells are shown with our regional adjustment for South East (above the UK average). Your quote is itemised and fixed in writing once the scope and specification are agreed.

How long does it take?

Allow 2–10 working days on site for a typical job. Drawings, approvals and long-lead items such as kitchens or fire door sets are booked before we start.

When do Royal Tunbridge Wells landlords need it?

We usually get the call when:

  • An HHSRS finding or council letter
  • Tenant reports of damp or mould

Questions about damp, mould and HHSRS repairs in Royal Tunbridge Wells

Is damp always rising damp?

No. In shared houses condensation is the most common cause, because of cooking, showers and drying clothes. We find the cause before recommending any treatment.

How far do you travel from Royal Tunbridge Wells?

We cover the whole of Kent and work UK-wide. For Royal Tunbridge Wells the nearest towns on our list are Tonbridge (4 miles), Crowborough (7 miles), Sevenoaks (10 miles).

Does a shared house in Royal Tunbridge Wells need an HMO licence?

In England, a mandatory licence is needed for 5 or more people from 2 or more households. Smaller HMOs can need a licence where the council runs additional licensing, which is common in towns with many shared houses. Check the council’s website for the address.

How much do damp, mould and HHSRS repairs cost in Royal Tunbridge Wells?

Our guide ranges for South East are in the table on this page, and the guide-price tool gives a figure for your house. A fixed written quote follows a free site visit.

Damp, mould and HHSRS repairs near Royal Tunbridge Wells

Other HMO services in Royal Tunbridge Wells

Planning HMO works?

Free site visit, then a fixed written quote itemised against your council’s standards.

CallGet a quote